YASKAWA SGMJV User Manual page 302

7 Utility Functions (Fn
Step
10
11
12
13
(2) Related Parameters
The EasyFFT related parameters are listed below. These parameters will be automatically set and the user
need not set them manually.
Pn408
Pn409
Pn40C
Pn456
7-34
)
Display after
Operation
Display blinks
Pn408=n. 1
Pn409=1250 (Hz)
MODE/SET
MODE/SET
Run ready status
MODE/SET
Turn OFF the power and then turn ON again to validate the setting.
Parameter
n. 0 Disables 1st notch filter. (Factory setting)
n. 1
Uses 1st notch filter.
n. 0 Disables 2nd notch filter. (Factory setting)
n. 1 Uses 2nd notch filter.
1st Notch FIlter Frequency
Setting Range Setting Unit
50 to 5000
2nd Notch FIlter Frequency
Setting Range Setting Unit
50 to 5000
Sweep Torque Reference Amplitude
Setting Range Setting Unit
1 to 800
Keys
After the detection completes normally, press the MODE/
SET Key. The optimum notch filter for the detected fre-
quency is automatically set. When the notch filter is set
correctly, the display "donE" blinks.
When the 1st notch filter frequency is already set
(Pn408=n
automatically set (Pn40C).
Notes:
DATA/
• If both the 1st and 2nd notch filter frequencies are
already set (Pn408 = n. 1
cannot be set any more.
• Set Pn408 = n.
use the notch filter frequency detected by executing
EasyFFT function.
Press the MODE/SET Key to return to the display of run
ready status.
DATA/
Press the DATA/SHIFT Key for approximately one second.
"Fn206" is displayed again.
DATA/
Meaning
Speed
Factory Setting
1 Hz 5000
Speed
Factory Setting
1 Hz 5000
Speed
Factory Setting
1% 15
Operation
1), the 2nd notch filter frequency will be
), a notch filter frequency
0 (disables 1st notch filter) not to
When Enabled Classification
Immediately
Position Torque
Classification
When Enabled
Immediately
Position Torque
Classification
When Enabled
Immediately
Position Torque
Classification
When Enabled
Immediately
Setup
Tuning
Tuning
Tuning