Ver.248
Drive Parameter Setting Tables
Introduction
This appendix lists the user-programmable parameters for the WJ200 for version2 series inverters and
the default values for European and U.S. product types. The right-most column of the tables is blank, so
you can record values you have changed from the default. This involves just a few parameters for most
applications. This appendix presents the parameters in a format oriented toward the keypad on the
inverter.
Parameter Settings for Keypad Entry
WJ200 for version2 series inverters provide many functions and parameters that can be configured by
the user. We recommend that you record all parameters that have been edited, in order to help in
troubleshooting or recovery from a loss of parameter data.
Inverter model
MFG. No.
Main Profile Parameters
NOTE:. Mark "" in A line of [ Run Mode Edit] shows the accessible parameters when b031 is not set "10",
high level access.
NOTE:. Mark "" in B line of [ Run Mode Edit] shows the accessible parameters when b031 is set "10",
high level access.
Func.
Code
Output frequency setting
Acceleration time (1)
Acceleration time (1),
2
motor
nd
Deceleration time (1)
Deceleration time (1),
2
nd
motor
Keypad RUN key routing
WJ200
"F" Function
Name
Standard default target
frequency that determines
constant motor speed, range is
0.0 / start frequency to
maximum frequency (A004)
Standard default acceleration,
range is 0.01 to 3600 seconds.
Standard default deceleration,
range is 0.01 to 3600 seconds.
Two options; select codes:
Forward
Reverse
This information is printed
on the specification label
located on the right side of
the inverter
Run
Mode
Edit
Description
A
Defaults
B
Initial data
Units
0.0
Hz
10.0
s
10.0
s
10.0
s
10.0
s
00