Hitachi WJ200-001S Instruction Manual page 433

Wj200 series single/three-phase inputs 200v/400v class

Hide thumbs Also See for WJ200-001S:

Table of Contents

14.1.3 PM mode switching

It changes to the PM mode by setting the initialization trigger (b180) to 01 after setting the inverter mode

selection (b171) to 03, and initialization is executed.

■When using this mode, observe the following precautions.

① hen 01 is set on the initialization trigger (b180), and SET key is pressed, initialization starts immediately

and there is not any way to restore the previous parameter setting.

② All data will be initialized regardless the setting of b094. b094

③ The settings of "P100" to "P131", running-time data, and power-on time data cannot be cleared.

④ When display is restricted by the function code display restriction function (b037) or software is locked by

the software lock function (b031), you cannot initialize because the function codes of initialization are

no-display. If you forget password that restrict setting (b031) and (b037), you cannot cancel it. (So you

cannot initialize when software lock is active, you note that the setting password. (See section 7.6.11 the

password function.))

Inverter mode selection

Initialization trigger

Function code

Data or range of data

Troubleshooting