Hitachi WJ200-001S Instruction Manual page 500

example wiring diagrams are in "Using Intelligent Output Terminals" in chapter 4.
Option Terminal
Function Name
Code Symbol
RUN Run Signal

FA1 Frequency Arrival

Type 1–Constant
Speed
FA2 Frequency Arrival

Type 2–Over frequency
OL Overload Advance

Notice Signal 1
OD Output Deviation for

PID Control
AL Alarm Signal

FA3 Frequency Arrival

Type 3–Set frequency
OTQ Over/under Torque

Signal
UV Undervoltage

TRQ Torque Limited Signal

RNT Run Time Expired

ONT Power ON time

Expired
THM Thermal Warning

BRK Brake Release Signal

BER Brake Error Signal

ZS Zero Hz Speed

Detection Signal
DSE Speed Deviation

Excessive
POK Positioning Completion ON

FA4 Frequency Arrival

Type 4–Over frequency
FA5 Frequency Arrival

Type 5–Set frequency
Output Function Summary Table
ON When the inverter is in Run Mode
OFF When the inverter is in Stop Mode
ON When output to motor is at the set frequency
When output to motor is OFF, or in any acceleration or
OFF
deceleration ramp
When output to motor is at or above the set freq., even if in
ON
accel () or decel () ramps
When output to motor is OFF, or at a level below the set
OFF
frequency
When output current is more than the set threshold () for
ON
the overload signal
When output current is less than the set threshold for the
OFF
deviation signal
When PID error is more than the set threshold for the
ON
deviation signal
When PID error is less than the set threshold for the
OFF
deviation signal
ON When an alarm signal has occurred and has not been cleared
When no alarm has occurred since the last cleaning of
OFF
alarm(s)
When output to motor is at the set frequency, during accel
ON
() and decel ().
When output to motor is OFF, or is not at a level of the set
OFF
frequency
ON Estimated motor torque exceeds the specified level
OFF Estimated motor torque is lower than the specified level
ON Inverter is in Undervoltage
OFF Inverter is not in Undervoltage
ON Torque limit function is executing
OFF Torque limit function is not executing
ON Total running time of the inverter exceeds the specified value
Total running time of the inverter does not exceed the
OFF
specified value
Total power ON time of the inverter exceeds the specified
ON
value
Total power ON time of the inverter does not exceed the
OFF
specified value
ON
Accumulated thermal count exceeds the  set value
Accumulated thermal count does not exceed the  set
OFF
value
ON Output for brake release
OFF No action for brake
ON Brake error has occurred
OFF Brake performance is normal
ON
Output frequency falls below the threshold specified in 
Output frequency is higher than the threshold specified in
OFF

Deviation of speed command and actual speed exceeds the
ON
specified value .
Deviation of speed command and actual speed does not exceed
OFF
the specified value .
Positioning is completed
OFF Positioning is not completed
When output to motor is at or above the set freq., even if in
ON
accel () or decel () ramps
When output to motor is OFF, or at a level below the set
OFF
frequency
When output to motor is at the set frequency, during accel
ON
() and decel ().
When output to motor is OFF, or is not at a level of the set
OFF
frequency
Description
Ver.271