Hitachi WJ200-001S Instruction Manual page 271

464
Running Time and Power On Time Over Signal
The inverter outputs the operation time expiration signal and power on time expiration
signal.
To enable this function, assign
terminals.
Option Terminal
Code Symbol

RNT

ONT
Valid for inputs:
Required settings
Notes:
 The example circuit for terminal [11] drives a relay
coil. Note the use of a diode to prevent the
negative-going turn-off spike generated by the coil
from damaging the inverter's output transistor.
"
Function Name State
Run time expiration
signal
Power ON time
expiration signal
11, 12, AL0 – AL2

(RNT)", and/or " (ONT)" to intelligent output
ON Accumulated operation time of the inverter exceeds

the set value of
OFF Accumulated operation time of the inverter does not
exceed the set value of
ON Accumulated power on time of the inverter exceeds

the set value of
OFF Accumulated power on time of the inverter does not
exceed the set value of
Example for terminal [11] (default output
configuration shown – see
Inverter output
terminal circuit
Example for terminal [AL0], [AL1], [AL2] (requires
output configuration – see
Inverter logic
circuit board
AL0
Power
supply
See I/O specs on
Description


page 3-89):
RNT
CM2 11
RY
page 4-51 and 3-91):
ONT
AL1 AL2
Load
page 4-6