Hitachi WJ200-001S Instruction Manual page 185

3100
Miscellaneous Functions
The following table contains miscellaneous functions not in other function groups.
Func.
Code
Debug mode enable *

Up/Down memory mode

selection
Reset selection

Restart mode after reset

UP/DWN clear mode

CAUTION: Do not change the debug mode for safety reasons. Otherwise unexpected
performances may occur.
"C" Function
Name
Displays debug parameters.
Two option codes:
Disable
Enable <Do not set>
(for factory use)
Controls speed setpoint for the
inverter after power cycle.
Two option codes:
Clear last frequency (return
to default frequency )
Keep last frequency adjusted
by UP/DWN
Determines response to Reset
input [RS].
Four option codes:
Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
Cancel trip state at input ON
transition, no effect if in Run
Mode
Clear the memories only
related to trip status
Determines the restart mode after
reset is given, three option codes:
Start with 0 Hz
Start with freq. matching
Start with active freq.
matching
Freq. set value when UDC signal
is given to the input terminal, two
option codes:
0 Hz
Original setting (in the
EEPROM memory at power
on)
Description
Defaults
Run
Mode
Initial data Units
Edit
00

00

00

00

00





