Hitachi WJ200-001S Instruction Manual page 146

User Parameter Registration
Parameter group "U" is the user parameter. Any function code can be chosen to registor
on this parameter up to 32. When display mode is set to be "user parameter" (= )
then is  to and , ,  are displayed.
Func.
Name
Code
Function code display

restriction
User parameters 1 to 32



Automatic User Parameter Registration
The automatic user parameter setting function allows you to make the inverter
automatically record changed function codes in  to . You can use the stored
function codes as a history of data change. To enable this function, select "" (enabling
automatic user parameter setting) for the .
When any data is changed and SET key is pressed, the function code will be stored in
U001 to U032 sequentially.
The latest data is in , and the oldest one is in .
Stored function codes in  to  are not duplicated. If duplicated function code is
changed, old existing function code is deleted. If number of changed function code
exceeds 32, the oldest one in  is deleted.
Func.
Name
Code
Automatic user parameter

registration
User parameters 1 to 32



"b" Function
Description
Six option codes:
Full display
Function-specific display
User setting (and )
Data comparison display
Basic display
Monitor display only
Set range,
 
" ,
"b" Function
Description
Two option codes:
Disable
Enable
Set range,
 
" ,
361
Defaults
Run
Mode
Initial data Units
Edit
00 



Defaults
Run
Mode
Initial data Units
Edit
00 


