Hitachi WJ200-001S Instruction Manual page 119

334
PID deviation output – If PID deviation "" exceeds the value in , output signal
configured as  (OD) is activated.
PID feedback comparison output – If PID feedback is out of the range between 
and  output signal configured as  (FBV) is activated.
FW input
FBV output
PID scaling – When PID scale parameter () is set, following variables are scaled.
(monitored) = (variable) ×（A075）
d004
A023
A031
PID Sleep Function
The inverter shuts off the output when the PID output becomes less than the specified
value () in case of PID is set enabled, or shuts off when the frequency command
becomes less than the specified value in case of PID is set disabled. And if the PID
output or frequency command exceeds the specified value () for a specified period
(), inverter automatically restarts the operation. This is the PID sleep function.
PID output
PID sleep function
triggering level
Run command (internal)
Run command (external)
PID Sleep function is always enabled, even the PID function is disabled.

PID feedback
ON
ON
F001 A011
A024 A025
A032 A033


PID sleep function action delay time
Run
ON
A012 A020
A026 A027
A034 A035
Stop
Run

PID FBV output high limit

PID FBV output low limit
Time
A220 A021
A028 A029
A101 A102

Run
A022
A030
A145