F" Group: Main Profile Parameters - Hitachi WJ200-001S Instruction Manual

"F" Group: Main Profile Parameters

The basic frequency (speed) profile is
defined by parameters contained in the
"F" Group as shown to the right. The
set running frequency is in Hz, but
acceleration
specified in the time duration of the
ramp (from zero to maximum frequency,
or from maximum frequency to zero).
The motor
determines whether the keypad Run
key produces a FWD or REV command.
This parameter does not affect the
intelligent terminal [FW] and [REV]
functions, which
separately.
Acceleration 1 and Deceleration 1 are the standard default accel and decel values for the
main profile. Accel and decel values for an alternative profile are specified by using
parameters x through x. The motor direction selection () determines the
direction of rotation as commanded only from the keypad. This setting applies to any
motor profile (1st or 2nd) in use at t particular time.
Func.
Name
Code
Output frequency setting

Acceleration time (1)

Acceleration time (1),

2 motor
nd
Deceleration time (1)

Deceleration time (1),

2 motor
nd
Keypad RUN key routing

Acceleration and deceleration can be set via EzSQ as well via the following parameter.
Func.
Name
Code
Acceleration/Deceleration

setting source selection
and deceleration
direction parameter
you configure
"F" Function
Standard default target
frequency that determines
constant motor speed, range is
0.0 / start frequency to
maximum frequency (A004)
Standard default acceleration,
range is 0.01 to 3600 sec.
Standard default deceleration,
range is 0.01 to 3600 sec.
Two options; select codes:
 Forward
 Reverse
"P" Function
Two options; select codes:
 Via operator
 Via EzSQ
Output
frequency

are


0
Description
Description
 
Actual decel. time
Actual accel. time
Defaults
Run
Mode
Initial data
Edit
 0.0
 10.0
 10.0
 10.0
 10.0
 00
Run Defaults
Mode
Initial data
Edit
00

311
t
Units
Hz
sec.
sec.
sec.
sec.

Units
-