Hitachi WJ200-001S Instruction Manual page 144

359
specify data displayed on the integrated operator on powerup. The table below lists the
display items selectable. (The factory setting is  [].)
Panel display selection:  – When an external operator is connected to WJ200 via
RS-422 port, the display is locked and shows only one parameter configured by .
Automatic return to the initial display:  – 10 min. after the last key operation,
display returns to the initial parameter set by .
Frequency conversion coefficient setting:  – By setting , converted output
frequency is monitored in . ( =   )
Frequency set in monitoring:  – If  is set in , frequency can be changed by
up/down key in monitor display  and .
Action selection in case of external operator disconnection:  – When an external
operator is disconnected, the inverter behaves according to  setting.