Hitachi WJ200-001S Instruction Manual page 405

C− − − − 18
Func.
Code
Watt-hour display gain
b079
Start frequency
B082
Carrier frequency
B083
Initialization mode
B084
(parameters or trip history)
Country for initialization
B085
Frequency scaling conversion
B086
factor
STOP key enable
B087
Restart mode after FRS
B088
Automatic carrier frequency
b089
reduction
Dynamic braking usage ratio
b090
"b" Function
Name
Set range is,
1.~1000.
Sets the starting frequency for the
inverter output, range is 0.10 to
9.99 Hz
Sets the PWM carrier (internal
switching frequency), range is 2.0
to 15.0 kHz
Select initialized data, five option
codes:
00...Initialization disabled
01...Clears Trip history
02...Initializes all Parameters
03...Clears Trip history and
04...Clears Trip history and
Select default parameter values
for country on initialization, two
option codes:
00...area A
Specify a constant to scale the
displayed frequency for D007
monitor, range is 0.01 to 99.99
Select whether the STOP key on
the keypad is enabled, three option
codes:
00...Enabled
01...Disabled always
02... Disabled for stop
Selects how the inverter resumes
operation when free-run stop
(FRS) is cancelled, three options:
00...Restart from 0Hz
01...Restart from frequency
02...Restart from frequency
Three option codes:
00...Disabled
01...Enabled, depending on the
02...Enabled, depending on the
Selects the rate of use (in %) of the
regenerative braking resistor per
100 sec. intervals, range is 0.0 to
100%.
0%: Function disabled
>0%: Enabled, per value
Description
initializes all parameters
initializes all parameters and
EzSQ program
01...area B
detected from real speed of
motor (freq. matching)
detected from real speed of
motor (active freq. matching)
output current
heat-sink temperature
Run
Mode Defaults
Edit
A B Initial data Units
1.
0.50 Hz
10.0 kHz
00
−
00
−
1.00
−
00
−
00
−
01 -
0.0 %