Hitachi WJ200-001S Instruction Manual page 98

Run Command Source Setting – For parameter , the following table provides a
further description of each option, and a reference to other page(s) for more information.
Code
Control terminal – The [FW] or [RV] input terminals control

Run/Stop operation
Keypad Run key – The Run and Stop keys provide control

ModBus network input – The network has a dedicated coil for

Run/Stop command and a coil for FW/RV
Option – Select when an option card is connected and use the

frequency source from the option
/ Override Sources – The inverter allows some sources to override the setting
for output frequency and Run command in  and . This provides flexibility for
applications that occasionally need to use a different source, leaving the standard
settings in /.
The inverter has other control sources that can temporarily override the parameter
 setting, forcing a different output frequency source. The following table lists all
frequency source setting methods and their relative priority ("1" is the highest priority).

Priority
1 [CF1] to [CF4] Multi-speed terminals
2 [OPE] Operator Control intelligent input
3 [F-TM] intelligent input
4 [AT] terminal

5
Frequency source setting
The inverter also has other control sources that can temporarily override the parameter
 setting, forcing a different Run command source. The following table lists all Run
command setting methods and their relative priority ("1" is the highest priority).

Priority
1 [OPE] Operator Control intelligent input
2 [F-TM] intelligent input

3
Run command source setting
Run Command Source
Frequency Source Setting Method
Run Command Setting Method
313
Refer to page(s)...
4-16
2-23
B-24
(manual of each
option)
Refer to page...
4-17
4-35
4-42
4-28
3-10
Refer to page...
4-35
4-42
3-10