Hitachi WJ200-001S Instruction Manual page 164

Wj200 series single/three-phase inputs 200v/400v class

Hide thumbs Also See for WJ200-001S:

Table of Contents

STO (Safe Torque Off) Setting

Please refer to the appendix E for detailed information.

GS input mode

Inverter Mode Setting

After switched Inverter mode to PM (Permanent magnetic) mode, Permanent magnetic

motor control is available. (Factory default is IM (Induction motor) mode)

PM mode is available only CT (HD) mode. (Parameter =)

The mode is not changed only Inverter mode set (parameter ). After changed the

Inverter mode, execute "Restoring Factory Default Settings"(parameter ), then the

Parameter is initialized, the inverter mode is changed. (This initialization needs no

parameter change of  like "Restoring Factory Default Settings".)

Current preset Mode can be monitored  display.

If you need such "Clears Trip history" or "Restoring Factory Default Settings" again at

PM mode, please set ,, parameters, then set , so that Initialization

will be executed.

 parameter setting is not required.

If you change from PM mode to IM mode, use ,  parameter setting & the

Inverter mode selection

"b" Function

Two option codes:

No trip (Hardware shutoff

"b" Function

Three option codes:

No function

Std. IM (Induction Motor)

PM(Permanent Magnet

Initial data

Initial data

Troubleshooting