7A – 18 HEATING AND VENTILATION SYSTEM
REPAIR INSTRUCTIONS
ON-VEHICLE SERVICE
D108A501
D108A502
D108A503
CONTROL ASSEMBLY AND
CONTROL CABLES
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the instrument cluster housing trim panel.
Refer to Section 9E, Instrumentation/Driver informa-
tion.
3. Remove the control assembly.
D Remove the control assembly retaining screws (1).
D Separate the control assembly from the instrument
panel (2).
D Disconnect the electrical connectors (3).
D Disconnect the mode control cable from the heater
module (4).
D Disconnect the temperature control cable from the
heater module (5).
D Remove the glove box from the instrument panel.
Refer to Section 9E, Instrumentation/Driver Infor-
mation.
D Disconnect the recirculating/fresh air door cable
from the blower module (6).
DAEWOO M-150 BL2