Daewoo MATIZ Service Manual page 1049

9I – 6 WATERLEAKS
6. Prime the trimmed area with the primer.
7. Using a sharp knife, trim off the uneven edges of the
adhesive material around the leak 75 to 100 mm (3 to
4 inches) on both sides of the leak.
D109A504
8. Allow the primer to dry for 5 minutes.
9. Apply the adhesive over the leak and for a distance
of 75 to 100 mm (3 to 4 inches) on both sides of the
leak.
D109A505
10. Immediately after applying the adhesive, use a flat
stick or a similar tool to work the adhesive into the
leak area and into the joint between the original ma-
terial and the vehicle body in order to ensure a wa-
tertight seal.
11. Spray warm or hot water over the repaired area in
order to determine if the leak was repaired. Do not
run a heavy stream of water directly on the freshly
applied adhesive.
12. Install the trim strip lace if it was removed.
13. Install the garnish molding if it was removed.
14. Install the reveal molding.
D109A506
Important: After the completion of any waterleak repair,
re–test the area using the watertest stands. Do not use
localized testing procedures on the newly–repaired
areas, as the repair material may dislodge under abnor-
mal pressure.
D109A304
DAEWOO M-150 BL2