Dtc 09 Driver Pretensioner Circuit, Resistance Too High - Daewoo MATIZ Service Manual

DTC 09
Step
1. Disconnect the negative battery cable.
2. Wait 1 minute for the SDM capacitor to discharge.
1
3. Examine the wiring and the connector at the
driver seat belt pretensioner module.
Is the connector disconnected?
1. Reconnect the driver seat belt pretensioner
module connector.
2
2. Reconnect the negative battery cable.
Is the repair complete?
1. Disconnect the electrical connector for the driver
seat belt pretensioner module.
2. Disconnect the electrical connector at the SDM.
D The shorting bar at the disconnected SDM
connector will create a complete circuit be-
tween the wires from the driver seat belt pre-
tensioner module.
3
3. Connect an ohmmeter to the terminals on the
SDM side of the wiring harness connector for the
driver seat belt pretensioner module.
D Refer to ''Diagnostic Illustration 16'' in this
section.
Does the ohmmeter show the specified value?
1. Replace the SDM.
2. Reconnect the negative battery cable.
4 3. Set the scan tool for CODE ERASE.
4. Do the diagnostic system check.
Does the code 09 still show as a current fault?
1. Replace the driver seat belt pretensioner module.
5
2. Reconnect the negative battery cable.
Is the repair complete?
1. Replace the supplemental inflatable restraints
(SIR) wiring harness.
6
2. Reconnect the negative battery cable.
Is the repair complete?
DAEWOO M-150 BL2
SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 31
–
Driver Pretensioner Circuit, Resistance Too High
Action Value(s) Yes
– Go to Step 2
Go to
Diagnostic
– System Check
≈ 0 W
Go to Step 4
– Go to Step 5
Go to
Diagnostic
– System Check
Go to
Diagnostic
– System Check
No
Go to Step 3
–
Go to Step 6
System OK
–
–