8B – 62 SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR)
Step
1. Turn the ignition ON.
2. Using a multimeter, check the voltage at the fuse
11
F1.
Does the multimeter show the specified value?
Repair the open power supply circuit for the fuse F1.
12
Is the repair complete?
1. Disconnect the connector C208.
2. Turn the ignition ON.
3. Using a multimeter, check the voltage on the
13
instrument harness side of the terminal 3 of the
connector C208.
Does the multimeter show the specified value?
1. Check the warning lamp bulb.
2. Replace the warning lamp bulb, if needed.
3. If the bulb is good, repair the open circuit between
14
the fuse F1 and the terminal 3 of the connector
C208.
Is the repair complete?
1. Disconnect the negative battery terminal.
2. Wait at least 1 minute before proceeding.
15
3. Replace the SIR wiring harness.
Is the repair complete?
DTC 25 – Warning Lamp Failure (Cont'd)
Action
Value(s)
Yes
11–14 v
Go to Step 13
Go to
Diagnostic
–
System Check
11–14 v
Go to Step 15
Go to
Diagnostic
System Check
–
–
System OK
No
Go to Step 12
–
Go to Step 14
–
–
DAEWOO M-150 BL2