Dtc 10 Driver Pretensioner Circuit, Resistance Too Low - Daewoo MATIZ Service Manual

DTC 10 – Driver Pretensioner Circuit, Resistance Too Low
Step
1. Disconnect the negative battery cable.
2. Connect an ohmmeter to the terminals of the
wiring harness connector for the driver seat belt
pretensioner module on the SDM side of the
1
connector.
D Refer to ''Diagnostic Illustration 16'' in this
section.
Does the ohmmeter show the specified value?
1. Replace the SDM.
2. Reconnect the negative battery cable.
2 3. Set the scan tool to CODE ERASE.
4. Do the diagnostic system check.
Does the code 10 still show as a current fault?
1. Replace the driver seat belt pretensioner module.
3 2. Reconnect the negative battery cable.
Is the repair complete?
1. Replace the supplemental inflatable restraints
(SIR) wiring harness.
4
2. Reconnect the negative battery cable.
Is the repair complete?
DAEWOO M-150 BL2
SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 33
Action Value(s) Yes
∞
Go to Step 2
– Go to Step 3
Go to
Diagnostic
– System Check
Go to
Diagnostic
– System Check
No
Go to Step 4
System OK
–
–