General Description And System Operation; General Repair Instructions - Daewoo MUSSO Service Manual

GENERAL DESCRIPTION
AND SYSTEM OPERATION

GENERAL REPAIR INSTRUCTIONS

If a floor jack is used, the following precautions are
recommended.
Park the vehicle on level ground, "block" the front or
rear wheels, set the jack against the frame, raise the
vehicle and support it with chassis stands and then
perform the service operation.
Before performing the service operation, disconnect
the negative battery cable in order to reduce the
chance of cable damaged and burning due to short-
cir cuiting.
Use a cover on the body, the seats and the floor to
protect them against damage and contamination.
Handle brake fluid and antifreeze solution with care
as they can cause paint damage.
The use of proper tools, and the recommended
essential and available tools where specified, are
important for efficient and reliable performance of
the service repairs.
GENERAL INFORMATION 0B-15
Use genuine DAEWOO parts.
Discard used cotter pins, gaskets, O-rings, oil seals,
lock washers and self-locking nuts. Prepare new ones
for installation. Normal function of these parts cannot
be maintained if these parts are reused.
Keep the disassembled parts neatly in groups to
facilitate proper and smooth reassembly.
Keep attaching bolts and nuts separated, as they
vary in hardness and design depending on the
position of the installation.
Clean the parts before inspection or reassembly.
Also clean the oil parts, etc. Use compressed air to
make certain they are free of restrictions.
Lubricate rotating and sliding faces of parts with oil
or grease before installation.
When necessary, use a sealer on gaskets to prevent
leakage.
Carefully observe all specifications for bolt and nut
torques.
When service operation is completed, make a final
check to be sure service was done properly and the
problem was corrected.