DAEWOO M-150 BL2
UNIT REPAIR
TIE ROD END BOOT
Disassembly Procedure
1. Remove the tie rod end. Refer to "Tie Rod End" in this
section.
2. Remove the tie rod end boot.
a. Tie rod end boot.
D105B701
Assembly procedure
Important : Coat the grease inside of the boot.
1. Install the boot to the tie rod end.
2. Install the tie rod end wire clamp.
3. Install the tie rod end. Refer to "Tie Rod End" in this
section.
D105B702
RACK AND PINION
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Disassembly Procedure
1. Remove the rack and pinion steering assembly from
the vehicle. Refer to "Rock and Pinion Assembly" in
this section.
2. Remove the rack and pinion boot.
D Remove the tie rod end. Refer to "Tie Rod End" in
this section (1).
D Remove the tie rod lock nut (2).
D105B703
D Remove the rack and pinion boot clamp (3).
D Cut off the rack and pinion boot wire (4).
MANUAL STEERING GEAR 6D – 11