Daewoo MATIZ Service Manual page 739

Table of Contents

Advertisement

Condition
Lash in the Steering
Column
Loose Steering
Wheel
Condition
Turn Signal Will Not
Stay in the Turn
Position
Turn Signal Will Not
Cancel
Turn Signal/Dimmer
Switch Difficult to
Operate
Turn Signal Will Not
Indicate Lane
Change
No Turn Signal
Lamps
Turn Indicator Lamps
On, But Not Flashing
Front or Rear Turn
Signal Lamps Not
Flashing
Turn Signal Lamps
Flash Very Slowly
DAEWOO M-150 BL2
Column (Cont'd)
Probable Cause
D Improperly installed steering column
bracket mounting nuts.
D Loose steering column housing–to–steering
column jacket support bolts.
D The bearing to be seated incorrectly in the
housing.
D Loose steering column housing support
bolts.
Turn Signal / Dimmer Switch
Probable Cause
D An improperly installed turn signal switch.
D The broken or missing components for the
cancelling mechanism.
D Foreign material in the turn signal switch
housing.
D Broken or missing components for the
cancelling mechanism.
D Improperly installed turn signal/dimmer
switch and turn signal/dimmer switch lever.
D Foreign material in the signal/dimmer
switch housing.
D A broken lane change pressure pad or a
broken spring hanger.
D The improper functioning of the lane
change spring.
D Improperly installed turn signal switch.
D An inoperative turn signal flasher.
D A faulty turn signal switch.
D Improperly connected chassis–to–column
connector.
D An inoperative blinker unit.
D An inoperative blinker unit.
D An inoperative blinker unit.
STEERING WHEEL AND COLUMN 6E – 5
D Tighten the steering column bracket
mounting nuts.
D Tighten the support bolts.
D Correctly seat the bearing.
D Replace the column housing as
needed.
D Tighten the steering column housing
support bolts.
D Remove and inspect the turn signal
switch.
D Reinstall the switch.
D Replace the turn signal switch.
D Remove any foreign material.
D Replace the turn signal switch.
D Remove and inspect the turn
signal/dimmer switch and
signal/dimmer switch lever.
D Reinstall the signal/dimmer switch
and signal/dimmer switch lever.
D Remove any foreign material.
D Replace the turn signal switch.
D Replace the turn signal switch.
D Replace the turn signal switch.
D Replace the blinker unit.
D Replace the turn signal switch.
D Reconnect the chassis–to–column
connector.
D Replace the blinker unit.
D Replace the blinker unit.
D Replace the blinker unit.
Correction
Correction

Advertisement

Table of Contents
loading

This manual is also suitable for:

My2003

Table of Contents