Blower Electrical - Daewoo MATIZ Service Manual

7A – 10 HEATING AND VENTILATION SYSTEM
Step
Verify the customer's complaint.
1
Are the customer's concerns verified.
Check the blower.
2
Does the blower run at any speed?
1. Disconnect the power connector from the blower
motor under the dashboard on the passenger side
of the vehicle.
2. Use an ohmmeter check the resistance between
3
the 1 terminal of the blower motor connector and
each step with the blower switch place each
position.
Does the ohmmeter show the specified value of the
each position?
Replace the blower motor.
4
Is the repair complete?
Check the fuse Ef6.
5
Is the fuse blown?
1. Turn the ignition ON.
2. Use a short detector to locate a possible short.
D From the fuse Ef6 to the blower switch.
D From the blower swtich to the blower resistor.
6
D From the blower resistor to the blower motor.
3. Repair any short.
4. Replace any blown fuse.
Is the repair complete?
1. Turn the ignition ON.
2. Disconnect the power connector from the blower
motor.
3. Use a test lamp to locate a possible short.
D From the terminal 2 of the motor connector to
the terminal 3 of the motor switch connector.
D From the terminal 2 of the motor connector to
7
the terminal 4 of the motor switch connector.
D From the terminal 2 of the motor connector to
the terminal 5 of the motor switch connector.
D From the terminal 2 of the motor connector to
the terminal 6 of the motor switch connector.
Does the test lamp light ON?
Replace the blower resistor.
8
Is the repair complete?
Replace the blower motor switch.
9
Is the repair complete?
1. Check the ground of the blower motor.
10 2. Repair the ground of the blower motor.
Is the repair complete?

BLOWER ELECTRICAL

Action Value(s) Yes
–
Go to Step 2
–
System OK
Refer to
"Specifica-
tions" in this
section. Go to Step 4
–
System OK
–
Go to Step 6
–
System OK
–
Go to Step 9
–
System OK
–
System OK
–
System OK
No
System OK
Go to Step 3
Go to Step 5
Go to Step 7
Go to Step 7
–
Go to Step 8
Go to Step 10
–
–
DAEWOO M-150 BL2