DTC 06 – Passenger Firing Circuit, Resistance Too Low
Step
1. Disconnect the negative battery cable.
2. Connect an ohmmeter to the terminals of the
wiring harness connector for the passenger
airbag module on the SDM side of the connector.
1
D Refer to ''Diagnostic Illustration 8'' in this
section.
Does the ohmmeter show the specified value?
1. Replace the SDM.
2. Reconnect the negative battery cable.
2
3. Set the scan tool to CODE ERASE.
4. Do the diagnostic system check.
Does the code 06 still show as a current fault?
1. Replace the passenger airbag module.
3
2. Reconnect the negative battery cable.
Is the repair complete?
1. Replace the supplemental inflatable restraints
(SIR) wiring harness.
4
2. Reconnect the negative battery cable.
Is the repair complete?
DAEWOO M-150 BL2
SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 25
Action
Value(s)
Yes
∞
Go to Step 2
–
Go to Step 3
Go to
Diagnostic
System Check
–
Go to
Diagnostic
System Check
–
No
Go to Step 4
System OK
–
–