Snmp-Server Enable Trap - Allied Telesis AT-AR3050S Command Reference Manual

SNMP C
OMMANDS
-
SNMP SERVER ENABLE TRAP

snmp-server enable trap

Overview Use this command to enable the switch to transmit the specified notifications
(traps).
Note that the Environmental Monitoring traps defined in the AT-ENVMONv2-MIB
are enabled by default.
Use the no variant of this command to disable the transmission of the specified
notifications.
snmp-server enable trap {[atmf] [atmflink] [atmfnode] [atmfrr]
Syntax
[auth] [bgp] [mstp] [nsm] [ospf] [pim] [thrash-limit] [vrrp]}
no snmp-server enable trap {[atmf] [atmflink] [atmfnode]
[atmfrr] [auth] [bgp] [mstp] [nsm] [ospf] [pim] [thrash-limit]
[vrrp]}
Default By default, no notifications are generated.
Mode Global Configuration
Usage This command cannot be used to enable link status notifications globally. To
enable link status notifications for particular interfaces, use the
link-status
To specify where notifications are sent, use the
Note that more than one trap can be configured with one command entry, and
also note this command applied to notifications send by SNMP version 3.
C613-50077-01 REV A
Parameter Description
atmf
AMF traps.
atmflink
AMF Link traps.
atmfnode
AMF Node traps.
atmfrr
AMF Reboot Rolling traps.
auth
Authentication failure.
bgp
BGP traps.
mstp
MSTP traps.
nsm
NSM traps.
ospf
OSPF traps.
pim
PIM traps.
thrash-limit
MAC address Thrash Limiting traps.
vrrp
Virtual Router Redundancy (VRRP) traps.
command.
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
snmp trap
snmp-server host command.
1963