Atmf Network-Name - Allied Telesis AT-AR3050S Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
ATMF NETWORK NAME

atmf network-name

Overview This command applies an AMF network name to a (prospective) AMF node. In
order for an AMF network to be valid, its network-name must be configured on at
least two nodes, one of which must be configured as a master and have an AMF
License applied. These nodes may be connected using either AMF downlinks or
crosslinks.
For more information on configuring an AMF master node, see
Use the no variant of this command to remove the AMF network name.
atmf network-name <name>
Syntax
no atmf network-name
Mode Global Configuration
Usage This is one of the essential commands when configuring AMF and must be entered
on each node that is to be part of the AMF. This command will not take effect until
the particular node is rebooted.
A switching node (master or member) may be a member of only one AMF network.
CAUTION
will cause the AMF network to fragment (at the next reboot).
Example To set the AMF network name to amf_net use the command:
Node_1(config)#
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<name>
: Ensure that you enter the correct network name. Entering an incorrect name
atmf network-name amf_net
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The AMF network name. Up to 15 printable characters
can be entered for the network-name.
atmf master.
1721