Allied Telesis AT-AR3050S Command Reference Manual page 1964

SNMP C
OMMANDS
-
SNMP SERVER ENABLE TRAP
Examples To enable the device to send a notification if an AMF node changes its status, use
the following commands:
awplus#
awplus(config)#
To enable the device to send MAC address Thrash Limiting traps, use the following
commands:
awplus#
awplus(config)#
To disable the device from sending MAC address Thrash Limiting traps, use the
following commands:
awplus#
awplus(config)#
To enable the device to send OSPF and VRRP-related traps, use the following
commands:
awplus#
awplus(config)#
To disable OSPF traps being sent out by the device, use the following commands:
awplus#
awplus(config)#
Related show snmp-server
Commands
snmp trap link-status
snmp-server host
C613-50077-01 REV A
configure terminal
snmp-server enable trap atmfnode
configure terminal
snmp-server enable trap thrash-limit
configure terminal
no snmp-server enable trap thrash-limit
configure terminal
snmp-server enable trap ospf vrrp
configure terminal
no snmp-server enable trap ospf
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
1964