Using The Built-In Editor; Snmp And Mibs - Allied Telesis AR400 SERIES User Manual

Hide thumbs Also See for AR400 SERIES:

Table of Contents

Operating the Router

Software Release 2.5.1

C613-02021-00 REV C

Using the Built-in Editor

The AR400 Series router has a built-in full-screen text editor for editing script

files stored on the router file subsystem. Using the text editor you can run

script files manually, or set script files to run automatically at router restart, or

on trigger events. Figure 3 on page 39 shows a example screen shot of the text

editor. To start the editor with a new file or an existing file, enter the command:

EDIT [filename]

Figure 3: The editor screen layout.

The editor uses VT100 command sequences and should only be used with a

VT100-compatible terminal, terminal emulation program or Telnet client.

To display editor Help at any time while in the editor press [Ctrl/K,H]; that is,

hold down the Ctrl key and press in turn the K key then the H key.

For more information about the inbuilt editor, see the Operation chapter in the

AR400 Series Router Software Reference.

You can remotely monitor some features of the router using Simple Network

Management Protocol (SNMP).

The following MIBs are supported:

MIB II (RFC 1213)

Ethernet MIB (RFC 1643)

AR400 router portion of the ATI/ATKK Enterprise MIB

Frame Relay DTE MIB (RFC 1325)

Bridge MIB (RFC 1493)

Table of Contents