Fail Count - Allied Telesis AT-AR3050S Command Reference Manual

P -P C
ING OLLING OMMANDS
-
SHOW PING POLL
Table 47: Parameters in output of the show ping-poll command (cont.)
Examples To display the ping poll settings and the status of all the polls, use the command:
awplus#
To display a summary of the ping poll settings, use the command:
awplus#
To display the settings for ping poll 6, use the command:
awplus#
To display a summary of the state of ping poll 6, use the command:
awplus#
To display the settings of ping polls that have reachable devices, use the
command:
awplus#
To display a summary of ping polls that have unreachable devices, use the
command:
awplus#
Related debug ping-poll
Commands
ping-poll
C613-50077-01 REV A
Parameter Description

Fail count

The number of pings that must be unanswered, within the total
number of pings specified by the
polling instance to consider the device unreachable. This is set
using the
Up count
The number of consecutive pings that the polling instance must
receive a reply to before classifying the device reachable again.
This is set using the
Sample size
The total number of pings that the polling instance inspects
when determining whether a device is unreachable. This is set
using the
Length
The number of data bytes to include in the data portion of the
ping packet. This is set using the
command.
Timeout
The time in seconds that the polling instance waits for a
response to a ping packet. This is set using the
polling)
Debugging
Indicates whether ping polling debugging is Enabled or
Disabled.
This is set using the
show ping-poll
show ping-poll brief
show ping-poll 6
show ping-poll 6 brief
show ping-poll state up
show ping-poll 6 state down brief
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
fail-count command.
up-count command.
sample-size command.
command.
debug ping-poll
sample-size command, for the
length (ping-poll data)
timeout (ping
command.
2090