Show Traffic-Shaping Interface - Allied Telesis AT-AR3050S Command Reference Manual

T S C
RAFFIC HAPING OMMANDS
-
SHOW TRAFFIC SHAPING INTERFACE

show traffic-shaping interface

Overview This command displays the traffic shaping settings on each interface. It displays
either the interface bandwidth and shaped bandwidth, or the interface
virtual-bandwidth. It also shows how much bandwidth has been reserved per
interface by traffic shaping rules, and how much bandwidth the default queue (for
traffic that is not matched by any rule) gets on each interface.
show traffic-shaping interface [<interface-name>]
Syntax
Usage You can use this command to check if an interface is over subscribed.
Default Displays all interfaces
Mode Privileged Exec
Examples To show traffic shaping configuration on all interfaces, use the following
commands:
awplus#show traffic-shaping interface
To show traffic shaping configuration on interface eth2, use the following
commands:
awplus#show traffic-shaping interface eth2
Output Figure 54-4: Example output from show traffic-shaping interface
C613-50077-01 REV A
Parameter
<interface-name>

awplus#show traffic-shaping interface 
Interface eth1: 
Virtual bandwidth:
Reserved bandwidth:
Default queue bandwidth:

Interface eth2: 
Interface bandwidth:
Shaped bandwidth:
Reserved bandwidth:
Default queue bandwidth:
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The name of the interface to display.
50000kbps 
0kbps 
50000kbps 
1000000kbps 
950000kbps 
15000kbps 
935000kbps 
2244