Show Interface Tunnel (Ipsec) - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
(IP
SHOW INTERFACE TUNNEL SEC

show interface tunnel (IPsec)

Overview Use this command to display status information of tunnels.
The tunnel remains inactive if no valid tunnel source or tunnel destination is
configured.
Syntax show interface tunnel<tunnel-index>
Mode Privileged Exec
To display brief status information for IPsec tunnel1, enter the command below:
Examples
awplus#
Output Figure 57-3: Example output from the show interface tunnel command
awplus#show interface11
Interface tunnel1
Link is UP, administrative state is UP
Hardware is Tunnel
IPv4 address 192.168.1.1/30 pointopoint 192.168.1.3
index 14 metric 1 mtu 1480
arp ageing timeout 300
<UP,POINTOPOINT,RUNNING,MULTICAST>
SNMP link-status traps: Disabled
Tunnel source 10.1.0.10, destination 10.2.0.10
Tunnel local 10.1.0.10, remote 10.2.0.10
Tunnel protocol/transport ipsec ipv4, key disabled, sequencing disabled
Tunnel TTL 64
Checksumming of packets disabled, path MTU discovery disabled
Tunnel protection via IPsec (profile "default")
input packets 11, bytes 924, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Time since last state change: 0 days 03:23:10
Related interface tunnel
Commands
C613-50077-01 REV A
)
Parameter Description
tunnel Specify this parameter to display tunnel
status information of a given tunnel
identified by the <0-255> parameter.
<tunnel-index>
Specify a tunnel index in the range from 0 through 255.
show interface tunnel1
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
2290