Allied Telesis AT-AR3050S Command Reference Manual page 1746

A T M F
LLIED ELESIS ANAGEMENT
-
ATMF WORKING SET
•
Note that the Implicit Groups do not appear in
If a node is an AMF master it will be automatically added to the master group.
Example 1 To add all nodes in the AMF to the working-set, use the command:
node1#
NOTE
comprises all nodes in the AMF.
This command displays an output screen similar to the one shown below:
Example 2 To return to the local prompt, and connect to only the local node, use the
command:
ATMF_Network_Name[6]#
node1#
The following table describes the meaning of the prompts in this example.
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Automatic Groups - These can be defined by hardware architecture, e.g.
x510, x610, x8100, AR3050S or AR4050S, or by certain AMF nodal
designations such as master.
atmf working-set group all
: This command adds the implicit group "all" to the working set, where "all"
=========================================
node1, node2, node3, node4, node5, node6:
==============================================

Working set join

ATMF_NETWORK_Name[6]#
Parameter
ATMF_Network_Name
[6]
node1
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
show atmf group
atmf working-set group local
Description
The name of the AMF network, as set by the
network-name command.
The number of nodes in the working-set.
The name of the local node, as set by the
command.
command output.
atmf
hostname
1746