Enable (Dpi) - Allied Telesis AT-AR3050S Command Reference Manual

A C C
PPLICATION ONTROL OMMANDS
(DPI)
ENABLE

enable (DPI)

Overview Use this command to enable DPI .
Use the no variant of this command to disable DPI without losing existing DPI
configuration.
Syntax enable
no enable
Default DPI is disabled by default.
Mode DPI Mode
Usage You need to use the
before enabling DPI.
When DPI is enabled, the DPI engine can classify network traffic and identify
today's most common applications.
DPI itself does not control or apply rules to the traffic. You can use the
(Firewall)
applications. You can use the
the applications being inspected by DPI.
DPI is disabled by default and all traffic is not classified.
Examples To enable DPI, use the commands:
awplus#
awplus(configt)#
awplus(config-dpi)#
awplus(config-dpi)#
To disable DPI, use the commands:
awplus#
awplus(config)#
awplus(config-dpi)#
Related provider procera
Commands
Validation show dpi
Commands
show running-config dpi
C613-50077-01 REV A
provider procera
command to enforce security policy and apply rules to the DPI
show dpi statistics
configure terminal
dpi
provider procera
enable
configure terminal
dpi
no enable
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command to configure the DPI provider
command to show statistics for
rule
2216