Allied Telesis AT-AR3050S Command Reference Manual page 1775

A T M F
LLIED ELESIS ANAGEMENT
SHOW ATMF GROUP
This confirms that the six nodes (node1 to node6) are now members of the
working-set and that these nodes reside within the AMF-NETWORK.
Note that to run this command, you must have previously entered the command
atmf working-set
which in this case is AMF_NETWORK[6]#.
Table 40: Sample output from the show atmf group command for a working
Table 41: Parameter definitions from the show atmf group command for a
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
ATMF group information

master, poe, x8100


===============================================
node1, node2, node3, node4, node5, node6:
===============================================

ATMF group information

sysadmin, x8100

AMF_NETWORK[6]#
on page 1745. This can be seen from the network level prompt,
set.
AMF_NETWORK[6]#show atmf group
===============================
node3, node4, node5, node6:
===============================

ATMF group information

edge_switches, x510
working set
Parameter
ATMF group information
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Definition
Displays a list of nodes and the groups that they
belong to, for example:
• master - Shows a common group name for Nodes
configured as AMF masters.
• Hardware Arch - Shows a group for all Nodes
sharing a common Hardware architecture, e.g.
x8100, x610, for example.
• User-defined - Arbitrary groups created by the
user for AMF nodes.
1775