Show Ips Categories - Allied Telesis AT-AR3050S Command Reference Manual

IPS C
OMMANDS

SHOW IPS CATEGORIES

show ips categories
Overview Use this command to show the IPS categories and their actions.
Note that if the IPS database provider is configured, this commands shows only the
provider's categories.
Syntax show ips categories
Mode Privileged Exec
Examples To show the IPS categories and their actions, use the command:
awplus#
Output Figure 47-3: Example output of built-in categories from the show ips
C613-50077-01 REV A
show ips categories
categories command
awplus#show ips categories 
Category (* = invalid)
--------------------------------------- 
checksum
ftp-bounce
gre-decoder-events
http-events
icmp-decoder-events
ip-decoder-events
ppp-decoder-events
smtp-events
stream-events
udp-decoder-events
Parameter Description
checksum 
Invalid checksums, e.g. IPv4, TCPv4, UDPv4, ICMPv4,TCPv6,
UDPv6, ICMPv6.
ftp-bounce 
GPL FTP PORT bounce attempt.
gre-decoder 
GRE anomalies, e.g. GRE packet too small, GRE wrong version,
events 
GRE v0 recursion control, GRE v0 flags, GRE v0 header too big,
GRE v1 checksum present, GRE v1 routing present, GRE v1 strict
source route, GRE v1 recursion control.
http-events 
HTTP anomalies, e.g. HTTP unknown error, HTTP gzip
decompression failed, HTTP request field missing colon, HTTP
response field missing colon, HTTP invalid request chunk len,
HTTP invalid response chunk len, HTTP status 100-Continue
already seen, HTTP unable to match response to request, HTTP
invalid server port in request.
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Action 
alert 
alert 
alert 
alert 
alert 
alert 
alert 
alert 
alert 
alert
2154