Atmf Master - Allied Telesis AT-AR3050S Command Reference Manual

Next-generation firewall

Hide thumbs Also See for AT-AR3050S:

Table of Contents

ATMF MASTER

This command configures the device to be an AMF master node and automatically

creates an AMF master group. The master node is considered to be the core of the

AMF network, and must be present for the AMF to form. The AMF master has its

node depth set to 0. Note that the node depth vertical distance is determined by

the number of uplinks/downlinks that exist between the node and its master.

An AMF master node must be present for an AMF network to form. Up to two AMF

master nodes may exist in a network, and they must be connected by an AMF

AMF, an AMF License is required for each master node.

If the crosslink between two AMF masters fails, then one of the masters will

become isolated from the rest of the AMF network.

Use the no variant of this command to remove the device as an AMF master node.

The node will retain its node depth of 0 until the network is rebooted.

value is 0).

no atmf master

The device is not configured to be an AMF master node.

Global Configuration

To specify that this node is an AMF master, use the following command:

node-1(config)#

show atmf group

C613-50077-01 REV A

: Master nodes are an essential component of an AMF network. In order to run

: Node depth is the vertical distance (or level) from the master node (whose depth

configure terminal

Command Reference for AT-AR3050S

AlliedWare Plus™ Operating System - Version 5.4.5-2.x

Show Quick Links

Table of Contents