Tunnel Mode (Ipsec) - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
(IP )
TUNNEL MODE SEC

tunnel mode (IPsec)

Overview Use this command to configure the encapsulation tunneling mode to use.
Use the no variant of this command to remove an established tunnel.
Syntax tunnel mode {gre [ipv6]|ipsec {ipv4|ipv6}|l2tp v3
[ipv6]|openvpn {tap|tun}}
no tunnel mode
Default Virtual tunnel interfaces have no mode set.
Mode Interface Configuration
Usage A tunnel will not become operational until it is configured with this command.
Examples To configure IPSec in IPv4 tunnel mode, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove configured IPSec tunnels for tunnel6, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
Parameter Description
gre
GRE IPv4 or IPv6 as the payload over IPv4 tunneling. IPv4 is the
delivery protocol.
gre ipv6
GRE IPv4 or IPv6 as the payload over IPv6 tunneling. IPv6 is the
delivery protocol.
ipsec ipv4
IPv4 IPsec tunnel
ipsec ipv6
IPv6 IPsec tunnel
l2tp v3
Layer 2 Tunneling Protocol version 3. By default, IPv4 is the deliver
protocol.
l2tp v3 ipv6 Set IPv6 as the deliver protocol for L2TPv3
openvpn
OpenVPN tunneling mode
openvpn tap
OpenVPN TAP mode
openvpn tun
OpenVPN TUN mode
configure terminal
interface tunnel6
configure terminal
interface tunnel6
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
tunnel mode ipsec ipv4
no tunnel mode
2312