Repeat - Allied Telesis AT-AR3050S Command Reference Manual

T C
RIGGER OMMANDS

REPEAT

repeat
Overview This command specifies the number of times that a trigger is permitted to activate.
This allows you to specify whether you want the trigger to activate:
•
•
•
Once the trigger has reached the limit set with this command, the trigger remains
in your configuration but cannot be activated. Use the repeat command again to
reset the trigger so that it is activated when its trigger conditions are met.
By default, triggers can activate an unlimited number of times. To reset a trigger to
this default, specify either yes or forever.
Syntax repeat {forever|no|once|yes|<1-4294967294>}
Mode Trigger Configuration
To allow trigger 21 to activate only once, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-trigger)#
To allow trigger 22 to activate an unlimited number of times whenever its trigger
conditions are met, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
To allow trigger 23 to activate only the first 10 times the conditions are met, use
the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
Related show trigger
Commands
trigger
C613-50077-01 REV A
only the first time that the trigger conditions are met
a limited number of times that the trigger conditions are met
an unlimited number of times
Parameter
yes|forever
no|once
<1-4292967294>
configure terminal
trigger 21
configure terminal
trigger 22
configure terminal
trigger 23
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The trigger repeats indefinitely, or until disabled.
The trigger activates only once.
The trigger repeats the specified number of times.
repeat no
repeat forever
repeat 10
2043