Dport - Allied Telesis AT-AR3050S Command Reference Manual

A E C
PPLICATION AND NTITY OMMANDS

DPORT

dport
Overview Use this command to specify a destination port or port range for an application.
A port number is part of the addressing information used to identify a specific
process to which a network message is to be forwarded between a sender and a
receiver. For the full list of port numbers and their assignment, you can visit the
Internet Assigned Numbers Authority (IANA) Web site: www.iana.org.
Use the no variant of this command to delete a port or a port range from an
application. Note that
NOTE
The port or port range that you want to delete must match exactly the existing port
or port range. You cannot remove a port range that is part of an existing port
range.
dport {<destination-port>|any|<start-range> to <end-range>}
Syntax
no dport {<destination-port>|any|<start-range> to <end-range>}
Mode Application Mode
Usage You can create more than one destination port number or port range for an
application.
To specify destination port 13 for application openVPN, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-application)#
To specify destination port 15 and port ranges for application openVPN, use the
commands:
awplus#
awplus(config)#
awplus(config-application)#
awplus(config-application)#
awplus(config-application)#
C613-50077-01 REV A
:
Parameter
<destination-port>
any
<start-range>
to <end-range>
configure terminal
application openVPN
configure terminal
application openVPN
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The destination port number, either TCP or UDP, specified
as an integer in the range <1-65535>.
Any port number in the range <1-65535>. This equals to a
range of 1 to 65535.
Starting port number in the range <1-65535>.
Ending port number in the range <1-65535> or max.
dport 13
dport 15
dport 30 to 37
dport 50 to max
2117