Tunnel Remote Name (Ipsec) - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
(IP )
TUNNEL REMOTE NAME SEC

tunnel remote name (IPsec)

Overview Use this command to specify a tunnel remote name to authenticate the tunnel's
remote peer device when you apply
packets and configure an ISAKMP key.
Use the no variant of this command to remove a previously configured tunnel
remote name.
tunnel remote name <remote-name>
Syntax
no tunnel local name
Default The default tunnel remote name is the IP address of tunnel destination.
Mode Interface Configuration
To configure tunnel remote name office2 for tunnel6, use the commands
Examples
below:
awplus#
awplus(config)#
awplus(config-if)#
To remove a configured tunnel local name for tunnel6, use the commands
below:
awplus#
awplus(config)#
awplus(config-if)#
Related tunnel local name (IPsec)
Commands
C613-50077-01 REV A
Parameter
<remote-name>
configure terminal
interface tunnel6
configure terminal
interface tunnel6
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
tunnel protection ipsec (IPsec)
Description
Destination tunnel hostname
tunnel remote name office2
no tunnel remote name
to encrypt the
2314