Network (Entity) - Allied Telesis AT-AR3050S Command Reference Manual

A E C
PPLICATION AND NTITY OMMANDS
(E )
NETWORK NTITY

network (Entity)

Overview Use this command to add a network to a zone entity or configure an existing
network.
A network is a high level abstraction of a logical network in a zone. This consists of
the IP subnets and interfaces over which it is reachable. Subnets are grouped into
networks to apply a common set of rules among the subnets.
Use the no variant of this command to destroy a network entity.
network <network-name>
Syntax
no network <network-name>
Mode Zone Mode
Usage A network is a member of a zone. You can create multiple networks in a zone. A
network entity is identified with its parent zone using the dot notation, for
example, ZoneName.NetworkName.
This commands allows you to enter the Network Mode with the prompt
awplus(config- network)#. In the Network Mode, you can:
•
•
A network must have at least one valid network address for it to result in
functioning rules using that network entity. For more information about how to
add network address, see the
Note that if the network entity is destroyed, the subnets and hosts in the network
entity will be destroyed as well.
To create a network entity named servers, use the commands:
Example
awplus#
awplus(config)#
awplus(config-zone)#
awplus(config-network)#
C613-50077-01 REV A
Parameter Description
<network-name> Network name.
You can use all alphanumeric ASCII characters, and the dash (-)
and underscore (_) characters. The name can be 1 to 64
characters in long.
Configure subnets and interfaces for the network entity
Create and delete host entities in the network
configure terminal
zone dmz
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
ip subnet command and the
network servers
ipv6 subnet command.
2135