Tunnel Dscp - Allied Telesis AT-AR3050S Command Reference Manual

GRE T C
UNNELING OMMANDS

TUNNEL DSCP

tunnel dscp
Overview Use this command to configure the Differentiated Services Code Point (DSCP)
value for the DSCP field in the packet header that encapsulates the tunneled
packets.
Use the no variant of this command to reset the DSCP field to its default value.
Syntax tunnel dscp <0-63>
no tunnel dscp
Default The IPv4 DSCP field value is inherited from the inner header to the outer header.
Mode Interface Configuration
To configure the DSCP value to 10 for tunnel2, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To remove a configured DSCP value for tunnel2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related interface tunnel
commands
tunnel mode (GRE)
C613-50077-01 REV A
Parameter Description
<0-63>
Specify the DSCP value in the range from 0 through 63 for the
DSCP field in the packet header that encapsulates the tunneled
packets.
configure terminal
interface tunnel2
configure terminal
interface tunnel2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
tunnel mode gre
tunnel dscp 10
no tunnel dscp
2336