Allied Telesis AT-AR3050S Command Reference Manual page 1759

A T M F
LLIED ELESIS ANAGEMENT
SHOW ATMF AREA
Table 6: Example output from the show atmf area command on a remote master.
Canterbury#show atmf area 

ATMF Area Information: 

* = Local area

Area
Name
----------------------------------------------------------------------------
NZ
* Canterbury

Area count:
Table 7: Parameter definitions from the show atmf area command
Parameter
*
Area Name
Area ID
Local Gateway
Remote Gateway
Remote Master
Node Count
Area Count
Area Node Count
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS

Area Local
ID Gateway
1 Reachable
3 Reachable
2
Definition
Indicates the area of the device on which the command is being run.
The name of each area.
The ID of the area.
Whether the local gateway node is reachable or not.
Whether the remote gateway node is reachable or not. This is one of the following:
• Reachable, if the link has been established.
• Unreachable, if a link to the remote area has not been established. This could
mean that a port or vlan is down, or that inconsistent VLANs have been configured
using the switchport atmf-arealink remote-area
• N/A for the area of the controller or remote master on which the command is
being run, because the gateway node on that device is local.
• Auth Start, which may indicate that the area names match on the controller and
remote master, but the IDs do not match.
• Auth Error, which indicates that the areas tried to authenticate but there is a
problem. For example, the passwords configured on the controller and remote
master may not match, or a password may be missing on the remote master.?
• Auth OK, which indicates that area authentication was successful and you can
now use the atmf select-area
Whether the remote master node is reachable or not. This is N/A for the area of the
controller or remote master on which the command is being run, because the
master node on that device is local.
The number of nodes in the area.
The number of areas controlled by the controller.
The total number of nodes in the area.
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Remote Remote
Gateway Master
N/A N/A
N/A N/A
Local area node count:
command.
command.
Node
Count

-

40
40
1759