Dpd-Interval - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
-
DPD INTERVAL

dpd-interval

Overview Use this command to specify the Dead Peer Detection (DPD) interval for an ISAKMP
profile.
DPD is an IKE mechanism using a form of keep-alive to determine if a tunnel peer
is still active.
The interval parameter specifies the amount of time the device waits for traffic
from its peer before sending a DPD acknowledgment message.
Use the no variant to set the interval to its default (30 seconds).
dpd-interval <10-86400>
Syntax
no dpd-interval
Default If you do not specify an interval, the default interval of 30 seconds applies.
Mode ISAKMP Profile Configuration
Examples To specify a DPD interval, use the following commands:
awplus(config)#
awplus(config-isakmp-profile)#
To set the interval to its default, use the following commands:
awplus(config-isakmp-profile)#
Related crypto isakmp profile
Commands
Validation show isakmp profile
Commands
C613-50077-01 REV A
Parameter Description
<10-86400>
Interval expressed in seconds.
crypto isakmp profile my_profile
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
dpd-interval 20
no dpd-interval
2281