Ip Subnet - Allied Telesis AT-AR3050S Command Reference Manual

A E C
PPLICATION AND NTITY OMMANDS

IP SUBNET

ip subnet
Overview Use this command to add an IPv4 subnet to a network entity.
Use the no variant of this command to remove a subnet from a network entity.
Syntax ip subnet <ip-network/m> [interface <interface-name>]
no ip subnet <ip-network/m> [interface <interface-name>]
Mode Network Mode
Usage You can create multiple subnets to a network entity.
To add a subnet to network servers, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-zone)#
awplus(config-network)#
To add a subnet and an interface to network servers, use the commands:
awplus#
awplus(config)#
awplus(config-zone)#
awplus(config-network)#
C613-50077-01 REV A
Parameter
<ip-network/m>
interface
<interface-name>
configure terminal
zone dmz
configure terminal
zone dmz
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
IP address of the network, entered in the form
A.B.C.D/M. Dotted decimal notation followed
by a forward slash, and then the subnet mask
length.
Specify an interface name. An interface may
be specified to add a further restriction on
the subnet. No interface configured indicates
that any matching address from any interface
is a member of this network.
Interface name. Any AlliedWare Plus interface
type (eth, vlan, ppp, tunnel, lo and so on).
A warning message is given if the interface
does not match an existing interface on the
device.
network servers
ip subnet 192.168.2.0/24
network servers
ip subnet 192.168.2.0/24 interface eth1
2129