Ip Radius Source-Interface - Allied Telesis AT-AR3050S Command Reference Manual

RADIUS C
OMMANDS
-
IP RADIUS SOURCE INTERFACE

ip radius source-interface

Overview This command configures the source IP address of every outgoing RADIUS packet
to use a specific IP address or the IP address of a specific interface. If the specified
interface is down or there is no IP address on the interface, then the source IP
address of outgoing RADIUS packets depends on the interface the packets leave.
Use the no variant of this command to remove the source interface configuration.
The source IP address in outgoing RADIUS packets will be the IP address of the
interface from which the packets are sent.
ip radius source-interface {<interface>|<ip-address>}
Syntax
no ip radius source-interface
Default Source IP address of outgoing RADIUS packets depends on the interface the
packets leave.
Mode Global Configuration
Examples To configure all outgoing RADIUS packets to use the IP address of the interface
"vlan1" for the source IP address, use the following commands:
awplus#
awplus(config)#
To configure the source IP address of all outgoing RADIUS packets to use
192.168.1.10, use the following commands:
awplus#
awplus(config)#
To reset the source interface configuration for all outgoing RADIUS packets, use
the following commands:
awplus#
awplus(config)#
Related radius-server host
Commands
C613-50077-01 REV A
Parameter
<interface>
<ip-address>
configure terminal
ip radius source-interface vlan1
configure terminal
ip radius source-interface 192.168.1.10
configure terminal
no ip radius source-interface
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Interface name.
IP address in the dotted decimal format A.B.C.D.
1578