Move Rule (Firewall) - Allied Telesis AT-AR3050S Command Reference Manual

F C
IREWALL OMMANDS
(F )
MOVE RULE IREWALL

move rule (Firewall)

Overview Use this command to change the order of firewall rules.
Firewall rules are applied in rule ID order. When rules match the same application,
source entity and destination entity, only the rule with the lowest ID is applied.
Note that you can move an existing rule ID only to an ID that is not assigned to any
rule; otherwise you will be given an error message. Also note that a change to the
rule order may change the rule results.
move rule <1-65535> to <1-65535>
Syntax
Mode Firewall Configuration
To change the rule ID from 20 to 10, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-firewall)#
Validation show firewall rule
commands
show running-config firewall
Related rule (Firewall)
commands
C613-50077-01 REV A
Parameter
move rule
<1-65535>
to <1-65535>
configure terminal
firewall
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Move the ID of a given rule. The rule ID of the given rule
must exist.
Each rule has an ID which is either designated by the user or
automatically generated when the rule is created. The rule
ID is an integer from 1 to 65535.
New rule ID to assign. The new rule ID must not be used by
any existing rule.
move rule 20 to 10
2102