Ipv6 Dhcp Server - Allied Telesis AT-AR3050S Command Reference Manual

DHCP IP 6 (DHCP 6) C
FOR V V OMMANDS
6
IPV DHCP SERVER

ipv6 dhcp server

Overview Use this command in Interface Configuration mode to enable DHCPv6 server for
the current IPv6 configured interface to use the specified DHCPv6 server pool
name.
The DHCPv6 server service listens for DHCPv6 requests on the IPv6 configured
interface. The DHCPv6 server service does not run on interfaces without IPv6
configured on them.
Use the no variant of this command to disable the DHCPv6 server.
ipv6 dhcp-server [<DHCPv6-poolname>]
Syntax
no ipv6 dhcp-server
Mode Interface Configuration
Usage The ipv6 dhcp server command enables the DHCPv6 service on a specified
interface using the pool for prefix delegation and configuration through the
specified interface.
Note that DHCPv6 client, DHCPv6 server and DHCPv6 relay are mutually exclusive
on an interface. When one of the DHCPv6 functions is enabled on an interface then
another DHCPv6 function cannot be enabled on the same interface.
Examples To enable the DHCPv6 server service and use the DHCPv6 pool named P2 on VLAN
interface vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the DHCPv6 server on VLAN interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 dhcp pool
Commands
show ipv6 dhcp binding
show ipv6 dhcp pool
C613-50077-01 REV A
Parameter
<DHCPv6-poolname>
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Specify a named DHCPv6 server pool as defined with the
ipv6 dhcp pool command. Valid characters are any
printable character. If the name contains spaces then you
must enclose it in "quotation marks".
ipv6 dhcp server P2
no ipv6 dhcp server
1900