Radius-Server Timeout - Allied Telesis AT-AR3050S Command Reference Manual

RADIUS C
OMMANDS
-
RADIUS SERVER TIMEOUT

radius-server timeout

Overview Use this command to specify the RADIUS global timeout value. This is how long the
device waits for a reply to a RADIUS request before retransmitting the request, or
considering the server to be dead. If no timeout is specified for the particular
RADIUS server by the radius-server host command, it uses this global timeout
value.
Note that this command configures the timeout parameter for RADIUS servers
globally.
The no variant of this command resets the transmit timeout to the default (5
seconds).
radius-server timeout <seconds>
Syntax
no radius-server timeout
Default The default RADIUS transmit timeout on the system is 5 seconds.
Mode Global Configuration
Examples To globally set the device to wait 20 seconds before retransmitting a RADIUS
request to unresponsive RADIUS servers, use the following commands:
awplus#
awplus(config)#
To set the RADIUS timeout parameter to 1 second, use the following commands:
awplus#
awplus(config)#
To set the RADIUS timeout parameter to the default (5 seconds), use the following
commands:
awplus#
awplus(config)#
To configure the RADIUS server timeout period globally with 3 seconds, use the
following commands:
awplus#
awplus(config)#
C613-50077-01 REV A
Parameter Description
<seconds>
RADIUS server timeout in seconds in the range 1 to 1000.
The global time in seconds to wait for a RADIUS server to reply to
a request before retransmitting the request, or considering the
server to be dead (depending on the radius-server retransmit
command).
configure terminal
radius-server timeout 20
configure terminal
radius-server timeout 1
configure terminal
no radius-server timeout
configure terminal
radius-server timeout 3
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
1586