Show Traffic-Shaping Rule Config-Check - Allied Telesis AT-AR3050S Command Reference Manual

T S C
RAFFIC HAPING OMMANDS
-
SHOW TRAFFIC SHAPING RULE CONFIG

show traffic-shaping rule config-check

Overview This command displays information you can use to verify which Traffic Shaping
commands that have been configured are valid, and why invalid rules are invalid.
This is useful because invalid rules are not applied, and so will have no impact on
the traffic flow.
show traffic-shaping rule [<10-9999>] config check
Syntax
Default Displays all rules
Mode Privileged Exec
Usage A traffic shaping rule can be invalid because:
•
•
•
•
•
•
•
•
•
•
Examples To check the validity of all rules, use the following commands:
awplus#show traffic-shaping rule config-check
To check the validity of rule 15, use the following commands:
awplus#show traffic-shaping rule 15 counters
C613-50077-01 REV A
-
CHECK
Parameter Description
<10-65535>
The ID of the rule whose counters should be displayed.
The application does not exist
The application does not have a protocol configured
The source entity does not exist
The source entity does not have a subnet or host address
The source entity has a subnet with an interface that does not exist
The destination entity does not exist
The destination entity does not have a subnet or host address
The destination entity does not have an interface
The destination entity has a subnet with an interface that does not exist
The source and destination entities do not have any subnet or host
addresses in the same address family (IPv4/IPv6
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
2247