Atmf Area - Allied Telesis AT-AR3050S Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF AREA

atmf area
Overview This command creates an AMF area and gives it a name and ID number.
Use the no variant of this command to remove the AMF area.
This command is only valid on AMF controllers, master nodes and gateway nodes.
atmf area <area-name> id <1-126> [local]
Syntax
no atmf area <area-name>
Mode Global Configuration
Usage This command enables you to divide your AMF network into areas. Each area is
managed by at least one AMF master node. Each area can have up to 120 nodes,
depending on the license installed on that area's master node.
The whole AMF network is managed by up to 8 AMF controllers. Each AMF
controller can communicate with multiple areas. The number of areas supported
on a controller depends on the license installed on that controller.
You must give each area in an AMF network a unique name and ID number.
Only one local area can be configured on a device. You must specify a local area on
each controller, remote AMF master, and gateway node.
Example To create the AMF area named New-Zealand, with an ID of 1, and specify that it is
the local area, use the command:
controller-1(config)#
To configure a remote area named Auckland, with an ID of 100, use the command:
controller-1(config)#
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<area-name>
<1-126>
local
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The AMF area name. The area name can be up to 15
characters long. Valid characters are: 
a..z
A..Z
0..9
-
_
Names are case sensitive and must be unique within an
AMF network. The name cannot be the word "local" or an
abbreviation of the word "local" (such as "l", "lo" etc.).
An ID number that uniquely identifies this area.
Set the area to be the local area. The local area contains the
device you are configuring.
atmf area New-Zealand id 1 local
atmf area Auckland id 100
1687